05-02-2007 08:59 PM - edited 03-03-2019 04:48 PM
Router 1841 doesn;t show temperature status when I run command sh env whereas 2800 is showing.The IOS is 12.4 on both
Kindly suggest??
Output:
sh env
FAN 1 Running sucessfully
ILP Power Supply - Absent
05-03-2007 08:17 AM
Hi,
the 18xx does not support temperature monitor, where did you saw differently ?
hope this helps, please rate post if it does!
05-05-2007 08:14 PM
Do you have any link saying this
It works on 2800 but not in 1800
05-06-2007 04:32 AM
1800 and 2801 does not have a temperature sensor.
2811 and bigger models do have.
This is the way it is.
05-06-2007 08:38 PM
No dear its not correct it does have onboard temp sensor
Please check this link
http://www.cisco.com/en/US/products/ps5853/products_installation_guide_chapter09186a0080458a31.html
Still not able to figure out why its not showing temp with sh env command
05-07-2007 01:37 AM
Hello,
I think you have misread the document. It does not says that the 1800 has a temperature meter, it simply says that the FAN is temperature-controlled:
Cisco 1800 series fixed-configuration routers have an internal multispeed fan that provides chassis cooling, controlled by an onboard temperature sensor. The internal fan operates at a continuously variable speed to minimize fan noise while providing sufficient chassis cooling.
So you can go around as much as you want, no thermometer, sorry.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide