Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 1921 sample working config for VDSL with a VA-DSL-A card?

The problem i'm running into is all the sample configs for this card i'm finding are for much older code, i need it for a 1921 with version 15.2(3)T.

Any help is very much appreciated.

  • WAN Routing and Switching
2 REPLIES

Cisco 1921 sample working config for VDSL with a VA-DSL-A card?

Hi,

I believe you have an EHWIC-VA-DSL-A card installed on the C1921 device.

The sample configuration for the same would be as follows,

1. Configure the Controller,

controller VDSL 0/0/0

operating mode vdsl2

firmware filename flash:vdsl.bin-A2pv6C035j1

2. Configure the Ethernet interface & its sub-interface as follows,

interface Ethernet0/0/0

no ip address

l

interface Ethernet0/0/0.2

encapsulation dot1Q 2  ---------> Need to confirm the VLAN TAG ID from the ISP

pppoe enable group global

pppoe-client dial-pool-number 1

!

3. Configure the Dialer interface and as per you requirements, you can configure the Authentication, IP addressing etc.

interface Dialer1

ip address negotiated

ip nat outside

ip virtual-reassembly in

encapsulation ppp

load-interval 30

dialer pool 1

dialer-group 1

ppp authentication pap chap callin

ppp chap hostname _______

ppp chap password ________

ppp pap sent-username ______ password _______

Let me know if this was what you were looking for and if it works for you.

Regards,

Mithun

New Member

Hi Mithun,

Hi Mithun,

Thank You for your example above, as I am currently trying to set this up as well.  One question though....does the ehwic-VA-dsl-A module come with software by default, or do you need the "firmware filename flash:vdsl.bin-A2pv6C035j1" command and the firmware for VDSL on the router?  Thanks.

Eddie

1110
Views
0
Helpful
2
Replies