Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Cisco 1921 support VWIC2-1MFT-T1/E1

Hi all,

I am going to replace a router into a new model 1921. But, on existing router, there is a module "VWIC2-1MFT-T1/E1". I am planning to put this module onto new router.

Is there anyone know did 1921 support "VWIC2-1MFT-T1/E1"?

Thanks,

Bell

  • WAN Routing and Switching
1 REPLY
VIP Gold

Read Module Support on Cisco

Read Module Support on Cisco’s Integrated Services Routers Generation 2 (Table 2, Multiflex Trunk Voice & WAN Interface Cards). It claim VWIC2-1MFT-T1/E1 supported from 12.3(14)T firmware.

Then read Cisco 1900 Series Integrated Services Routers - Interfaces and Module it mention no VWIC2 kind of module supported. 

I suspect (but just guessing) the support for VWIC2-* has been removed from 15.* firmware.

So the answer depends on the firmware version you will have installed on the device.

And note that no pre-15 firmwares are avaiable for download from Cisco ...

1
Views
0
Helpful
1
Replies