As pointed out by Michal, there are timed commands, like "reload at XXX" or "reload in XXX", but those commands are never written into configuration and cannot be saved. Therefore the router can restart like that only once, and not continuously. If it regularly restarts, then there is a problem.
Check "show version" output to see the reason for reload.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...