Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 2514 Router

Hi All,

I am new to this site so appologies if I am in the wrong place.  I have just bought a 2514 router to start my CCENT study's.  When I turn on my router and connect via console through TeraTerm I get the following text and then I cant do anything.  Can someone point me in the right direction.

Thanks

System Bootstrap, Version 5.0(6), RELEASE SOFTWARE

Copyright (c) 1986-1994 by cisco Systems

2500 processor with 1024 Kbytes of main memory

F3: 3834088+95972+196644 at 0x3000060

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.

           170 West Tasman Drive

           San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 3000 Software (IGS-I-L), Version 11.1(24a), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Fri 09-Mar-01 19:43 by pnicosia

Image text-base: 0x03020728, data-base: 0x00001000

%SYS-3-BADRESID: Clock hardware returned bad residual 0cisco 2500 (68030) processor (revision C) with 1024K/1024K bytes of memory.

Processor board ID 01510459, with hardware revision 00000000

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

2 Ethernet/IEEE 802.3 interfaces.

2 Serial network interfaces.

32K bytes of non-volatile configuration memory.

4096K bytes of processor board System flash (Read ONLY)

3 REPLIES
Silver

Cisco 2514 Router

New Member

Cisco 2514 Router

Thanks for the quick rspons, unfortunaltley when the router boots and I get the prompt "Press return to get started" nothing happens

Silver

Cisco 2514 Router

Did you read those links? You need to break into ROMMON mode and install a new IOS. If it still does not work after that you might be looked at dead hardware.

194
Views
0
Helpful
3
Replies
CreatePlease to create content