Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 2600 Serial Port Connection

I am working on configuring communication Router to Router through serial port. I have seen some videos and read some documentations. My configuration is as follows: 

R1 (DCE) -> f0/0 192.168.1.1/24 - s0/0 192.168.2.1/24 <-----> Router2 ->(DTE)  S0/1 192.168.2.2/24 f0/0 192.168.3.1.

I have configured the routing tables at both routers. It works when I ping from router to router and router to hosts successfully. Nevertheless, I can ping from hosts to the default gateways, but I cannot ping from hosts to the serial ports (adjacency). In short I cannot communicate from Network1 to Network2. Please do I have to do any extra configuration.

1 REPLY
New Member

This discussion has been

This discussion has been reposted from Top Contributors to the WAN, Routing and Switching community.

44
Views
0
Helpful
1
Replies
CreatePlease to create content