Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2600 WIC-1ADSL Configuration to Qwest ISP

Could somebody point me in the right direction...

Here is my current config build for a Cisco 2620 using a Wic-1ADSL to connect to a Qwest ADSL ISP:

--------------------

interface FastEthernet0/0

ip address 172.16.0.1 255.255.0.0

ip nat inside

no ip mroute-cache

speed 100

full-duplex

interface ATM0/1

no ip address

no ip mroute-cache

no atm ilmi-keepalive

dsl operating-mode auto

pvc 32/0

encapsulation aal5mux ppp dialer

dialer pool-member 1

interface Dialer1

ip address negotiated

ip nat outside

ip nbar protocol-discovery

encapsulation ppp

dialer pool 1

dialer-group 1

ppp authentication chap pap callin

ppp chap hostname #############

ppp chap password 0 #############

ppp pap sent-username ############## password 0 ###########

--------------------

For some reason, it won't connect at all. I've changed the callin requirement on the ppp authentication between "callin" to "callout" - even removed the line completely for a no-authentication scenario.

The only responses that come back on a repetative nature when doing a debug are:

Vi2 PPP: Authorization NOT required

and

Vi2 PPP: No remote authorization for call-out

Could somebody be so kind to throw me in the right direction on what I'm missing in this config build? (I called Qwest customer support, and *no joke*, the actually gave me Cisco's 1-800 number)

As always, thank you guys so much for helping.

2 REPLIES
New Member

Re: Cisco 2600 WIC-1ADSL Configuration to Qwest ISP

Layer2 info was backwards in that config, it should read PVC 0/32.

But even switching between aal5mux and aal5snap encapsulation, the link won't come up - or any of the changes that I listed in the first post.

Any ideas would be greatly appreciated.

New Member

Re: Cisco 2600 WIC-1ADSL Configuration to Qwest ISP

Did you ever figure out your config on this? I am trying to ge my wic 1 ADSL working on AT&T.

Regards,

Brandon

717
Views
0
Helpful
2
Replies