my Troubleshooting:
s1:rommon>confreg
s2:
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]:
enable "use net in IP bcast address"? y/n [n]:
disable "load rom after netboot fails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect"? y/n [n]:
enable "ignore system config info"? y/n [n]:
change console baud rate? y/n [n]:
change the boot characteristics? y/n [n]: y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
[0]: 2
S3:ROMMON> Reset
No progress
S4：ROMMON>DIR FLASH:
c2800nmc-spservicesk9-mz.150-1.M7.bin
s5: boot flash:c2800nmc-.bispservicesk9-mz.150-1.M7.bin
No progress
but,found.
Readonly ROMMON initialized
AUTOBOOT entry: NVRAM VALUES: bootconf: 0x2, autobootstate: 0
autobootcount: 0, autobootsptr: 0x0
Autoboot state 0 BOOT variable returns: cptr = 0x0
autoboot about to execute command buffer: "boot flash:"
cptr = 0x0
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
loadprog: error - Invalid image for platform
e_machine = 213, cpu_type = 135
boot: cannot load "flash:"
autoboot: returned from boot command
AUTOBOOT exit: NVRAM VALUES: bootconf: 0x2, autobootstate: 2
autobootcount: 0, autobootsptr: 0x0
autoboot: issue do_reset()
SOS !!!!!!!!!!!!!
Thank you very much.
