Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco 2800 reload get into rommon mode,but Cannot reply

 

 

 

my  Troubleshooting:

 

s1:rommon>confreg

s2:

do you wish to change the configuration? y/n  [n]:  y

enable  "diagnostic mode"? y/n  [n]:

enable  "use net in IP bcast address"? y/n  [n]:

disable "load rom after netboot fails"? y/n  [n]:

enable  "use all zero broadcast"? y/n  [n]:

enable  "break/abort has effect"? y/n  [n]:

enable  "ignore system config info"? y/n  [n]:

change console baud rate? y/n  [n]:

change the boot characteristics? y/n  [n]:  y

enter to boot:

 0 = ROM Monitor

 1 = the boot helper image

 2-15 = boot system

    [0]:  2

 

S3:ROMMON> Reset

No progress

 

 

S4:ROMMON>DIR FLASH:

c2800nmc-spservicesk9-mz.150-1.M7.bin

 

s5: boot flash:c2800nmc-.bispservicesk9-mz.150-1.M7.bin

No progress

 

but,found.

Readonly ROMMON initialized
AUTOBOOT entry: NVRAM VALUES: bootconf: 0x2, autobootstate: 0
autobootcount: 0, autobootsptr: 0x0
Autoboot state 0 BOOT variable returns: cptr = 0x0
autoboot about to execute command buffer: "boot flash:"
cptr = 0x0
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
loadprog: error - Invalid image for platform
e_machine = 213, cpu_type = 135 
boot: cannot load "flash:"
autoboot: returned from boot command

AUTOBOOT exit: NVRAM VALUES: bootconf: 0x2, autobootstate: 2
autobootcount: 0, autobootsptr: 0x0
autoboot: issue do_reset()

 

SOS !!!!!!!!!!!!!

 

Thank you very much.

Everyone's tags (1)
2 REPLIES
New Member

Supplement:flash-------

Supplement:

flash--------format

I would suggest to boot from

I would suggest to boot from network (tftp) with IP_BASE image.

After you will be  able to troubleshoot your flash (if it's the cause).

107
Views
0
Helpful
2
Replies