Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2800 Router - SDM doesn't work

Hi,

I have a Cisco 2800 Router and I'm unable to use the SDM for configuring the router. I get a error everytime I try to access router.

This is what the error message says, "ES Startup Error - ES has not been granted with the necessary privileges in order to startup successfully, or another unknown error occurred during startup. Please close all browser windows and try again by granting all requests."

I'm using the router straight out of the box. Configured the ip address so that I'm able to ping the router on my network. Any ideals what this error means or how to resolve?

thanks,

4 REPLIES
New Member

Re: Cisco 2800 Router - SDM doesn't work

error says that the privileges are not high enough to open the application.

Try this:

remove the username as follows,

Router(config)#no username

And re set it as follows,

Router(config)#username privilege 15 secret 0

New Member

Re: Cisco 2800 Router - SDM doesn't work

tried to change username and password as mentioned above, I still receive the same error message.

New Member

Re: Cisco 2800 Router - SDM doesn't work

Have a look at the post titled "SDM problems with new 1841 router" in the "Getting Started with LANs" forum.

New Member

Re: Cisco 2800 Router - SDM doesn't work

do you have java installed? if not use the real thing from java.com

405
Views
0
Helpful
4
Replies