I'm trying to forward some udp ports through to an inside server. I have tcp ports working just fine. First off is there a way so no matter what port an inside server tries to use it always translated to that static address (126.96.36.199) in my example?
ip nat inside source static 10.100.0.5 188.8.131.52 route-map static
route-map static permit 1
match ip address 120
access-list 120 deny ip host 10.100.0.5 10.100.0.0 0.0.255.255
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...