Cisco 2801 and Cisco Switch Trunk Port

[ThomasMull9000]

Hello Guys

can any one Help me the below scenerio

Sceniuor

1- Cisco Router

Eth0/0 : Ip address 192.168.1.1 /24   == connected my laptop of 192.168.1.2

Eth0/1: Ip address : 192.168.2.1 /24   = connected cisco swith

2 - Cisco Switch

VLAN 2 Name : Sales : ip address 192.168.3. 1 = connected computer 192.168.3.2

VLAN 3  Name : Marketing : ip addres 192.168.4.1 = connected computer 192.168.4.2

so i want my lapto that connected the router Eth0/0 Interface should access both VLAN 2 and VLAN 3 computers

so how i can create it pls help , and give me a helpfull link like video or document or youc an wrirte me below

thank you very much

[Leo Laohoo · Accepted solution]

Configuring InterVLAN Routing and ISL/802.1Q Trunking on a Catalyst 2900XL/3500XL/2950 Switch Using an External Router

[ThomasMull9000]

Thank You very much , this all wat i need eh .

God Bless u nd Guide you

[Leo Laohoo]

Glad to be of assistance Thomas.

[haneez2949]

Thomas,

After configuring ip routing in the switch.You need to route vlan 2 and vlan 3 in the router.

You may use either static route or any routing protocols.

So when the laptop reaches it's gateway.It will come to know where vlan 2 & 3 are situated.

Also don't forget to trunk the Eth0/1 port connecting to switch.

Thanks 
HNZ