Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 and NM-16ESW config

Please pardon the "rookie" questions...

I trying to configure a 2811 router with a NM-16ESW module installed.

I've got the T1 module configured, and it is working.

I have the NM-16ESW configured, and it will pass data between it's switch ports. But I can not get the data to pass from the switch ports to the router. I'd like to setup the switch ports as simply as possible, as I don't have any need for vlans at the remote site. I've attached the running config below.

If someone can point me in the direction of a document to configure this it would be appreciated.

Thanks.

Everyone's tags (1)
2 REPLIES
Hall of Fame Super Gold

Re: Cisco 2811 and NM-16ESW config

Change "ip default-gateway 10.110.214.1" to "ip route 0.0.0.0 0.0.0.0 10.110.214.1"

Hall of Fame Super Silver

Re: Cisco 2811 and NM-16ESW config

Hello Leo, Dksteinhauser

I have some doubts about what is the objective.

Leo: but that ip address is defined on a routed LAN port that is  not the WAN serial

interface FastEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0/0$
ip address 10.110.214.1 255.255.255.240
duplex auto
speed auto

the IP address used as a next-hop should be that of an external box, also the other box needs a static route for the IP subnet associated to vlan 192 to know that is connected to 2811.

I guess if this is a remote branch it should use the serial interface as outgoing link

ip route 0.0.0.0 0.0.0.0 ser0/0/0

but on other side the following are needed:

ip route 192.168.255.0 255.255.255.0  serx/y

ip route 10.110.214.0 255.255.255.240 serx/y

where serx/y is just a placeholder to be replaced with actual interface

if the link with the other box is via the routed lan port you need to use the correct IP address next-hop that can be 10.110.214.2 for example.

The other side will use an IP next-hop = 10.110.214.1

ip route 192.168.255.0 255.255.255.0  10.110.214.1

Hope to help

Giuseppe

1761
Views
0
Helpful
2
Replies