Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 can't see HWIC-1CE1T1-PRI

Hi, I have a HWIC-1CE1T1-PRI in a Cisco 2811 running IOS c2800nm-advipservicesk9-mz.124-18b.bin.

When I enter the "card type E1 0 0" command (it is in WIC 0 slot) I get the following response:

SYINDEV01RW02(config)#card type e1 1 0

^

% Invalid input detected at '^' marker.

Also the show inventory or show hardware commands do not appear to show this card at all.

Am I missing something here or does this look like the card is faulty?

2 REPLIES
Hall of Fame Super Blue

Re: Cisco 2811 can't see HWIC-1CE1T1-PRI

Steve

You need a minimum IOS of 12.4(20)T for this card, see Table 2 of the following doc -

https://www.cisco.com/en/US/prod/collateral/modules/ps2797/product_data_sheet0900aecd80710c88_ps5949_Products_Data_Sheet.html

so you need to upgrade your IOS.

Jon

New Member

Re: Cisco 2811 can't see HWIC-1CE1T1-PRI

OK, thanks for the response, will upgrade the IOS as you suggest. I did wonder if this was an issue.

1262
Views
0
Helpful
2
Replies