06-25-2009 05:56 AM - edited 03-04-2019 05:14 AM
As per title, are there any commands that tell what the RX/TX clocks you are seeing from your service provider/network provider?
Show controllers tells you that there are TX and RX clocks present but nothing else with respect to clocks as far as I can tell.
06-25-2009 10:18 AM
Hello Sean,
try
sh controller ser x/y
look for TX and RX clocks
Hope to help
Giuseppe
06-25-2009 10:39 AM
Giuseppe,
Tried that, only says that TX and RX clocks are present or something to that effect. No bandwidth or frequency value.
Sean.
06-25-2009 10:43 AM
Correct, not all hardware can read the clock values. You gotta trust what the SP says, or run some speed test.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: