Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 Router Not Booting

Hi

cisco 2811 router not booting.its produce following error

System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)

*** Emulating mis-aligned load at 0xe8ce3702       
Copyright (c) 2005 by cisco Systems, Inc.C = 0xbfc0a808 ... failed, opcode = 0x2b

Initializing memory for ECC

         
.

program load complete, entry point: 0x8000f000, size: 0xc940

*** Emulating mis-aligned loa

System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)a808 ...
failed, opcode = 0x2b02                                      
Copyright (c) 2005 by cisco Systems, Inc.e8ce3702b                              

Initializing memory for ECC08 ... failed, opcode = 0x2
.2
c2811 processor with 262144 Kbytes of main memorymulating mis-aligned load at
0xe8ce3702b        
Main memory is configured to 64 bit mode with ECC enabled failed, opcode = 0x2b02


Readonly ROMMON initializedaligned load at 0xe8ce3702b
program load complete, entry point: 0    
                            
*** Emulating mis-aligned load at 0xe8ce3702oad at 0xe8ce3702                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2bed, opcode = 0x2b

*** Emulating mis-aligned load at 0xe8ce3702oad at 0xe8ce3702                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2bed, opcode = 0x2b

*** Emulating mis-aligned load at 0xe8ce3702oad at 0xe8ce3702                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2bed, opcode = 0x2b

*** Emulating mis-aligned load at 0xe8ce3702oad at 0xe8ce3702                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2bed, opcode = 0x2b

    PC = 0xbfc0a808 ... failed, opcode = 0x2b02

*** Emulating mis-aligned load at 0xe8ce3702b                                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2b02

*** Emulating mis-aligned load at 0xe8ce3702b                                      
  
    PC = 0xbfc0a808 ... failed, opcode = 0x2b02

Please help me to resolve this issue

thanks in advance

Mohana sundaram.S

1 REPLY
Hall of Fame Super Gold

Re: Cisco 2811 Router Not Booting

Gee whiz!  I've never seen a bootstrap with THAT version.

Please contact Cisco TAC and raise an RMA request.  The bootstrap has "boned" itself.

1455
Views
0
Helpful
1
Replies
CreatePlease to create content