We have a cisco router 2811 so it has 2 IOS one is default IP- base and the other is c2800nm-ipbasek9-mz.124-20.T1 to support the E1-PRI card.
The router working fine then anfter 2-5 hours the service go down and after we access by Hyper temial we found it in the ROMMON1, we do switch off switch one then the router load the IOS and working well. this problem happen 2-4 times a day.
In addition to the suggestion from Leo I would suggest that you make sure that console logging is enabled to at least info level (if not debug) and connect a terminal to the console port. Then look to see if any console messages are generated that might show events as the router went into rommon.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...