I need to know the main differences between Cisco 2811 and Cisco 3825... the capabilities which one does have, but not the other?!
I went through both router's Data Sheets, but since I'm not an expert it's hard for me to point out the very main technical differences...
I need a help from an expert or anybody who have worked with these routers. Anybody can practically tell me what are the main capabilities of cisco 3825 over cisco 2811 or what's the point of choosing each one over the other!
Unfortunately I don't know about requirements. I've been asked to compare these two routers! Maybe my problem is that I don't know what should I look for when I'm going through router's spec.!
Any guidance or link for such comparisons, I'll appreciate it.
I have not gone back to look at the data sheets for those routers, so I do not have details. But in general the 3825 has a faster more powerful CPU than the 2811. The 3825 will take more memory than the 2811, so the 3825 would be considered more scalable than the 2811.
If you look at the throughput capabilities the 3825 will have a higher rating for packets per second and a higher bandwidth capability. You could terminate a T3/E3 on the 3825 but I am not sure that the 2811 would be capable of that. There are probably some network modules that are supported on the 3825 that are not supported on the 2811.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...