Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 w/ NM-ESW-16 Config for VLAN & WAN comms?

Anyone seen config assistance docs for back-to-back Cisco 2811's (simulated WAN w/ cross-over cable attached to Fa0/1) when using the network modules' access ports on each router, on common VLAN, to communicate across the WAN? (Cisco's one config example for NM-ESW-16 doesn't explain how to config for egressing to a WAN for comms w/ a similar router/NM-ESW hardware combination.) Thanks, in advance.

1 REPLY
Hall of Fame Super Gold

Re: Cisco 2811 w/ NM-ESW-16 Config for VLAN & WAN comms?

What is exactly that you want to simulate ? There is nothing special in the module, imagine that the VLAN router interfaces are connecting to a switch that you also configure under their respective interfaces.

Then it depends what do you mean by WAN connections, as thereare of various types.

593
Views
0
Helpful
1
Replies