Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2811 with High CPU usage

Hello

My router 2811 have high cpu usage (80%)

I haven't debug on my router.

When I take show proc cpu, the list of processes total up to less then 10%

I have lot of access-list (150) and 600 lines for it.

I have policy map for ftp, visio, P2P, smtp, ...

I have 15 ip inspect

100 Mb/s for the lan interface and 10Mb/s for the wan

I search command for see who is using the cpu.

Thanks,


2 REPLIES

Cisco 2811 with High CPU usage

Did you run 'sh proc cpu sorted' to see what's the highest process?

Is the high utilization constant?

It's possible that your ACLs/Policy Maps are causing high CPU utilization due to interrupts.

Are you getting hits on all the ACLs and all elements in those ACLs?

Cisco Employee

Re: Cisco 2811 with High CPU usage

Hi,

The show pro CPU output tells you most CPU cycle are on interrupt level. You are giving too much works to the router:) There isn't a command to show process under interrupt; I think you have to do CPU profile to find out that information.
http://www.itcertnotes.com/2011/03/cisco-router-cpu-profiling.html?m=1

HTH,
Lei Tian

Sent from Cisco Technical Support iPhone App

249
Views
0
Helpful
2
Replies
CreatePlease login to create content