Cisco 2811

[bericaleb]

I have a new 2811 which I've configured it a couple of times and seems to loose configurations everytime I perform a reboot. What am I missing here?

[Nagendra Kumar Nainar · Accepted solution]

HI Beri,

Hope you saved the configuration before booting the box :)

If so, check if the config-register is 2142,. If so, it will skip the startup config while booting.

You can verify it using the following command:

Router#sh ver | inc Configuration register

Configuration register is 0x2142

Router#

[guruprasadr]

HI,

Could you please post the Configuration of #sh run / #sh version

In addition check the Configuration Register No#

Do Rate all HELPFUL POSTS

Best Regards,

Guru Prasad R