Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2851 revert back to pervious setting after changes

It just changed back from a period of time suddenly. Initially I think I did not save it but looks like it's not the case as after I reload the module, it shown the changes I made, but for a period of time, it just revert back the change I made suddenly. As I do not make changes on the configure of the module very often (just sometimes add or remove mailbox or reset of password), so the configure I made is obvious if it gets revert back.

2 REPLIES
New Member

Re: Cisco 2851 revert back to pervious setting after changes

Make sure your config register is set properly.

New Member

Re: Cisco 2851 revert back to pervious setting after changes

I already check my register value and it's correct. But i'm using Cisco Unity Express to configure this router.

263
Views
0
Helpful
2
Replies