I have a Cisco 2901 router with giga interfaces and a Procurve 8212zl also with giga ports. Im seeing drops acumulating on the procurve port where the router is located. Have tried both auto on both ends, and static config with 1000FDX. Still im getting drops.
Any idea on how I can solve this ?
Please rate as helpful, if that would be the case. Thanx
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...