Okay I am new to here and have been reading reading posts here.
It seems that Cisco mentioned, in their data sheet of 2921 ISR, that it can support up to 50Mbps. However, from Google search, it says 2921 can handle 100Mbps with no problem.
I am planning on getting 2921 ISR in small office where only ~10 people are connected to it. And we do have two different line of 100Mbps ISP internet line and wish to share them in the office.
I am confused why ~$2k router can not support 100Mbps where ~$100 consumer routhers like Linksys has no problem with handling that speed. The reason why I am planning on 2921 is the rich feature like Voip solution (CME) it offeres. I have several remote offices that needs to be connected with Voip phones. and I could go with UC500 series but it seems to me UC500 does not support IP Phone 9900 series... so...
So can someone tell me if 2921 ISR support 100Mbps?
Re: Cisco 2921 ISR for routing 100Mbps ISP internet?
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Cisco rates the 2921 at 352 Kpps for 64 byte size packets. Since Ethernet requires 148.8 Kpps for 100 Mbps for 64 bytes size packets, 352 Kpps should handle 100 Mbps duplex, but this also assumes the router isn't supporting any services (and also usually assume all fast path processing).
Taking into account everything that you might want to do with traffic, from NAT, to firewall support, to QoS, Cisco recommends the 2921 for up to 50 Mbps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...