Hi, I am running into an issue on a Cisco 3640 ME switch.
Customer LAN ---- Customer Core switch --- 4 Gig Etherchannel—Cisco 3640 ME ---100 Meg Link ---Remote site router
If I do a file transfer from the remote site to the Customer LAN, all is good with a 98meg throughput, however if I do a file transfer from the Customer LAN to the remote site I only get a throughput of 45 Meg. I have check for the obvious half duplex issues etc. If I set the ports to 1Gig I do not get any issues, also if I set the ports connecting to the customer LAN to 100 meg, again no issues. This issues only occurs when the ME3640 s throttling the port to 100 Meg.
To rule out any hardware incompatibility I plugged two laptops into the same 3640ME switch, with one port at 1Gig and 1 port at 100Meg and I get exactly the same issue.
Any feedback or comments welcome that may fix this.
I can add config and Show Tech Support if required
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.