Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 3640 SDM Installation error

I am using Cisco 3640 /w IOS image 12.4(5) mainline. I tried to install Cisco Router Security Device Manager, SDM but failed. I did research on CCO and follow instructions to enable SDM installation but still got error as follow.

"rcp is denied through connected interface". Any clues?

1 REPLY

Re: Cisco 3640 SDM Installation error

Hi,

Did you install the common.tar files. I would recommend to install it again manually with all the related files.

Here are the steps:

Step 1: Upload the following files to the router's flash:

sdm.tar

common.tar

home.shtml

home.tar

sdmconfig-modelnum.cfg

Router#copy tftp: flash:

Address or name of remote host []? 10.10.10.1

Source filename []? sdm.tar

Destination filename [sdm.tar]?

%Warning:There is a file already existing with this name

Do you want to over write? [confirm]

Step 2: Enable the router's HTTP/HTTPS server, using the following Cisco IOS commands:

Router(config)# ip http server

Router(config)# ip http secure-server

Router(config)# ip http authentication local

If the router uses an IPSec Cisco IOS image, the HTTPS server is enabled. Otherwise only

the HTTP server is enabled.

Step 4 Create a user account with privilege level 15 (enable privileges).

Router(config)# username privilege 15 password 0

Replace and with the username and password that you want

to configure.

Step 5 Configure Telnet for local login and privilege level 15:

Router(config)# line vty 0 4

Router(config-line)# privilege level 15

Router(config-line)# login local

Router(config-line)# transport input telnet

Router(config-line)# exit

HTH, Please rate if it does.

-amit singh

505
Views
5
Helpful
1
Replies
CreatePlease to create content