10-01-2007 04:56 AM - edited 03-03-2019 06:58 PM
We have a Cisco 3660 Router with 3 E1 Cards installed of which 2 are NM-2CE1T1-PRI and 1 PRI2CE1B, when we are typing the command "card type E1 2/0" the IOS is giving the following error "% Urecongnized Command" also it is continously giving the following error on console "Controller E1 1/0 firmwire is not running". the IOS installed is c3660-ik9s-mz.123-15b.bin, please help us to resolve this issue is there any problem with the hardware of the Router.
10-01-2007 05:16 AM
Never used a command like "card type E1 2/0".
However, I have found the error message "Controller E1 1/0 firmwire is not running" is mostly due to a defective module.
regards,
Leo
10-01-2007 05:35 AM
Hi,
I think the command is "card type e1 slot_number" i.e. "card type e1 2" then "controller e1 slot_number/port_number" i.e. "controller e1 2/0"
12.3 and 12.3T supports the two modules but I'm not sure if "IP Plus IPSEC 3DES" supports E1 because the error "Controller E1 1/0 firmwire is not running" is either not support by IOS or hardware problem. I'll try to check it.
Regards,
Dandy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide