Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3660 with ASA 5505

Please help me out here....

I am stuck, I am trying to configure my home lab and I can't seem to find out how to do the following:

Internet -->ASA5505-->3660Router-->2900XL Switch --->ASA5505--->Wireless AP

Attached is an image  with a better idea of what I am wanting to do.

I have read that any router with the ASA is usless, but I would like to have the ASA just be a firewall/VPN and not much else.  Any help with this would be apprciated.

***All Cisco Equipment has basic configs loaded on them, if needed I can provide a show ver.

Home_Network.jpg

1 REPLY
Cisco Employee

Re: Cisco 3660 with ASA 5505

Hello,

From the diagram, it seems like you would like to assign 192.168.1.x address all across the board. You cannot do it with a router in between. Different router interfaces should have different IP addresses. So, in your case, it could be 192.168.1.x on the LAN side of 3660 and 192.168.2.x on the firewall side.

On the ASA:

interface vlan 1

nameif inside

security-level 100

ip address 192.168.2.1 255.255.255.0

exit

interface Ethernet 1

switchport access vlan 1

exit

global (outside) 1 interface

nat (inside) 1 0.0.0.0 0.0.0.0

route inside 192.168.1.0 255.255.255.0 192.168.2.2

On the 3660:

interface FastEthernet 0/0

description connection to ASA5505

ip address 192.168.2.2 255.255.255.0

no shut

exit

interface FastEthernet 0/1

description connection to 2900XL

ip address 192.168.1.1 255.255.255.0

no shut

exit

ip route 0.0.0.0 0.0.0.0 192.168.2.1

In this case, you do not need to make any changes on the ASA for the outside interface or the NAT settings. You are just introducing another subnet on the inside to make sure that you do not need to change IP address settings on the LAN.

Hope this helps.

Regards,

NT

302
Views
0
Helpful
1
Replies