There are some Cisco switches where I read that you could not enable both of these features because you either had a choice of one or the other, or the platform just did not support them.
In any case, can you enable both Jumbo frames and flowcontrol at the same time on a Cisco 3750X switch? Also, I only need to enable these features on 10 ports, so the rest of the ports should remain with defaults.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...