That is because most of the communication are bidirectional, you have deny ip any any on the inbound direction; your outgoing traffic can leave the interface but return traffic will be blocked by the ACL deny ip any any rule.
You can use reflexive acl to do that. The idea is when traffic leave the interface, it will create a temporary acl to allow the return traffic, and that acl will be added in your existing inbound acl 103. The configuration will look something like this
ip access ex OUTBOUND
permit ip any any ref temp
ip access ex INBOUND
permit ip any host x.x.x.227 log permit tcp any host x.x.x.57 eq 443 log permit udp any host x.x.x.57 eq 443 log evaluate temp deny ip any any log
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...