I have a 3825 that has 2 built in gb ports, what card do I need to add another gb port. A WAN card is more expensive then a gb card, does it have to be a wan card? These are all RJ45 copper connections
I want to duplicate what I have below with the 3825.
Any help would be appreciated,
Thanks in advance
interface FastEthernet0/0 description CONNECTION TO SERVER SWITCH no ip address no ip mroute-cache duplex full speed 100 no cdp enable ! interface FastEthernet0/0.10 description SERVER SWITCH 0/24 encapsulation dot1Q 10 ip address 192.168.0.254 255.255.255.0 ip nat inside ip virtual-reassembly ! interface FastEthernet0/1 description CONNECTION TO XXX NETWORKS no ip address no ip mroute-cache duplex full speed 100 no cdp enable ! interface FastEthernet0/1.100 description INTERNET encapsulation dot1Q 100 ip address 188.8.131.52 255.255.255.252 ip nat outside ip inspect fwout out ip virtual-reassembly no cdp enable ! interface FastEthernet0/1.4023 description OTHER LOCATTION OFFICE encapsulation dot1Q 4023 ip address 10.10.10.1 255.255.255.252 ip nat inside ip virtual-reassembly !
! interface FastEthernet0/0/0 description CONNECTION OFFICE SWITCH no ip address no ip mroute-cache duplex full speed 100 no cdp enable ! interface FastEthernet0/0/0.20 description OFFICE SWITCH 0/24 encapsulation dot1Q 20 ip address 192.168.1.254 255.255.255.0 ip nat inside ip virtual-reassembly
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...