Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 3845/HSEC

I purchased a Cisco 3845 with HSEC capability. This router should have an on onboard AIM-VPN hardware accelerator card (AIM-VPN/HPII-PLUS). I did a show version and it says there is one VPN module. What command can I execute to verify that the AIM-VPN/HPII-PLUS card is present on the router?

2 REPLIES
Bronze

Re: Cisco 3845/HSEC

Use the show diag 0 command to obtain hardware information about an installed AIM.

Check out this link

http://www.cisco.com/en/US/products/ps5855/products_installation_guide_chapter09186a00802ccf55.html#wp1008714

and scroll down to the verifying AIM installation section

HTH

New Member

Re: Cisco 3845/HSEC

I did a show diag 0 on the router and go the attached result. How can verfiy that the module in slot 0 is the AIM-VPN/HPII-PLUS

263
Views
0
Helpful
2
Replies
CreatePlease to create content