Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

cisco 3845-MB not picking up NM-2CE1T1-PRI

I installed the an NM-2CE1T1-PRI into a 3845-MB router and it didn't pickup.Why?

There's an existing NM-2CE1T1-PRI on the same router and it's working perfect. I tried installing it on slot 1. When I boot the router up I didn't see the module in the controllers section? Is there a command I should type in in order for me to see the additional controller?

1 REPLY

Re: cisco 3845-MB not picking up NM-2CE1T1-PRI

Hi,

After you insert the module and power up the router, you need to execute "card type" command. The controller will not be detected and cannot be configure until you execute "card type" command.

Reference http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a008045523c.html

Regards,

Dandy

421
Views
5
Helpful
1
Replies
CreatePlease to create content