Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3845 with increasing input errors, CRC and overrun

I have a 3845 that has increasing input errors, CRC and overrun on its g0/0 interface.  The 3845 is connected to a WS-C3750G-48PS.  The 3845's g0/0 is connected to the 3750's g2/0/1.  However, 3750's g2/0/1 has no input errors, CRC, or overrun.  Could this be an IOS bug?

Troubleshooting steps:

1.  restarted 3845 (still increasing)

2.  replaced cable between 3845 and 3750 (still increasing)

3.  moved connection from 3750's g2/0/1 to a new switchport (g2/0/7) - there were 0's across the board, but after a couple of hours, input errors, CRC, and overrun started to accrue again.

1 REPLY
Hall of Fame Super Silver

Re: Cisco 3845 with increasing input errors, CRC and overrun

Hello Pingmenow,

be aware that a C3845 is not capable to run a GE at wire speed so you can expect ignored or overrun when connected to a multilayer switch

may you post a sh int gi0/0 to see these counters and what is the ratio of input errors in comparison to correctly received packets (= input packets)

is the C3750 g2/0/1 a L2 interface for example a L2 trunk or is it a routed port?

(this is to understand what QoS features could be used on it)

Hope to help

Giuseppe

1026
Views
0
Helpful
1
Replies