Dear Sirs!
In my network, I use two Nexus 5596 and connect 3925 router to both switches by Port-channel and use few subinterfaces on the Po interface.
Now I need make L2TPv3 L2 channel to remote office over L3 channel, but I can not use xconnect command on the Po6.20 subinterface.
What can I make xconnect using Port-channel?
Thanks!
PS:
My two 3925 conncted together by provider VLAN, and provider not support MPLS. So i try to use L2TPv3.
--------------------------------------------------------------------------
Helping seriously ill children, all together. All information about this, is posted on my blog
