Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3945 misbehave, automatically defaults to rommod

Hi

We have bought a Cisco 3945, when we tried to configure it, it appears to misbehave. It automatically defaults to rommod

during configuration/ operation, is there anyone experienced the same?

Thanks
Everyone's tags (2)
1 REPLY
Hall of Fame Super Silver

Cisco 3945 misbehave, automatically defaults to rommod

Hello Echo,

a starting point is to verify the configuration register settings

follow this document to check and to eventually change the configuration register value

Typical value for a router like yours is 0x2102

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

you may have the break to rommon enabled that means the second hexadecimal digit not set.

Hope to help

Giuseppe

169
Views
4
Helpful
1
Replies
CreatePlease login to create content