Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 4500E VSS Configuration

Hi,

We configured two 4500E switches in VSS mode. Only one supervisor working each one of them. When we remove the fiber cable between switches VSL become down and each switch working standalone. It's good. We' re connected two switches over 10 Gig line cards, not over the supervisors. But while VSS is working if we unplug the supervisor module, line cards connections lost and when we plug the supervisor, the switch is rebooting. What we can do for preserve connections between two chassis.

Regards,

155
Views
0
Helpful
0
Replies