I am trying to run netflow on cisco 6500 with IOS s72033-advipservicesk9_wan-mz.122-18.SXF17b. Netflow software we are using is Netflow Analyzer 7 professional. I am getting the router and interfaces in the software but the traffic on the interface on the software is not increasing. Below is the configuration for reference.
mls flow ip full ip flow-export source Loopback100 ip flow-export version 5 ip flow-export destination "Netflow server" 9996
interface FastEthernet7/18 description ***TCL-International-MPLS*** ip address "Omitted" ip flow ingress speed 100 duplex full service-policy output Mum_MPLS_OUT end ! interface FastEthernet7/20 description ***MPLS link*** ip address "Omitted" ip flow ingress speed 100 duplex full service-policy output Mum_MPLS_OUT end
INMUMSYMCore1#sh ip flow export Flow export v5 is enabled for main cache Exporting flows to "Netflow server" (9996) Exporting using source interface Loopback100 Version 5 flow records 3686 flows exported in 2076 udp datagrams 0 flows failed due to lack of export packet 0 export packets were sent up to process level 0 export packets were dropped due to no fib 0 export packets were dropped due to adjacency issues 0 export packets were dropped due to fragmentation failures 0 export packets were dropped due to encapsulation fixup failures 0 export packets were dropped enqueuing for the RP 0 export packets were dropped due to IPC rate limiting 0 export packets were dropped due to Card not being able to export
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...