Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 7204 vxr, NPE G1 , dual PSU's

Hi,

Does anyone know of a command that will allow me to check if 1 of the 2 PSU's is faulty? I have an ongoing fault at the moment where 1 PSU is plugged into Comms Cabinet 1 which is fine but the 2nd PSU is plugged into a comms cabinet where the power is suspect. The command show environment all just shows that power is restored but I am looking for legacy information on the PSU.

Regards

Mary

3 REPLIES

Re: Cisco 7204 vxr, NPE G1 , dual PSU's

Hi,

try show environment all

Hope this helps,

Regards

Pravin

Hall of Fame Super Silver

Re: Cisco 7204 vxr, NPE G1 , dual PSU's

Hello Mary,

if you want to see what happened before you may check the logging buffer with sh log.

To verify if the PSU is working correctly you should connect it to a power source you know it is working fine.

the PSU should have some LEDs on them to signal if they are on (green) or faulty.

hope to help

Giuseppe

New Member

Re: Cisco 7204 vxr, NPE G1 , dual PSU's

Giuseppe

Nothing in log file and I am in a remote location so can't check PSU lights. I am surprised that there is no command to see if the PSU ever failed (nothing ever in logfile /environment log). Anyway, never mind, I give up!

Regards

mMary

104
Views
0
Helpful
3
Replies