cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
529
Views
0
Helpful
5
Replies

Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

pilgrim_travler
Level 1
Level 1

Hi everyone! 1st of all i'm interested in support of Distributed Traffic Shaping on NPE-G1 (fixed interfaces), 10nx in advance. The problem is: i create a policy map with classes within, make shape average and i can see Traffic Shaping values for amount of time, after 5-7 minutes the are no Traffic Shaping values like it's not shaping at all....

5 Replies 5

dgahm
Level 8
Level 8

Pilgrim,

Can you post your config, and the output of a show policy-map interfaceX/X

Dave

1st off all: c7200-jk9o3s-mz.124-8.bin

Cisco 7206VXR (NPE-G1)

and a part of output sh policy-map interface gigabitEthernet 0/1.5:

Class-map: Servers (match-all)

0 packets, 0 bytes

5 minute offered rate 0 bps, drop rate 0 bps

Match: access-group 2407

Traffic Shaping

Target/Average Byte Sustain Excess Interval Increment

Rate Limit bits/int bits/int (ms) (bytes)

1048576/1048576 32768 131072 131072 125 16384

Adapt Queue Packets Bytes Packets Bytes Shaping

Active Depth Delayed Delayed Active

- 0 0 0 0 0 no

After amount of time this Traffic Shaping disappears and traffic goes uncontrolled....and i thing it's happened when initializing bgp peering...

Your service policy needs to be applied to the physical interface gig0/1. The traffic shaping will not work when applied to the subinterface.

Please rate helpful posts.

Dave

I'm not quite sure that service policy is applied to the physical interface because it's work in similar configuration on other NPE-G1, and as i see in restrictions of DTS it's says:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dtdts.htm#1019899

DTS does not support the following:

* Fast EtherChannel, Tunnel, VLANs, and dialer interface

* Any VIP below a VIP2-40

And i understand VLAN's - vlan interfaces not subinterfaces

P.S.If it helps in the chassis i had an module (PA-2FE-TX) fault i removed the module and router seams to work ok, but not shaping...

pilgrim_travler
Level 1
Level 1

The problem is solved there is a bug: CSCsh67773

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card