Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

Hi everyone! 1st of all i'm interested in support of Distributed Traffic Shaping on NPE-G1 (fixed interfaces), 10nx in advance. The problem is: i create a policy map with classes within, make shape average and i can see Traffic Shaping values for amount of time, after 5-7 minutes the are no Traffic Shaping values like it's not shaping at all....

5 REPLIES
Blue

Re: Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

Pilgrim,

Can you post your config, and the output of a show policy-map interfaceX/X

Dave

New Member

Re: Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

1st off all: c7200-jk9o3s-mz.124-8.bin

Cisco 7206VXR (NPE-G1)

and a part of output sh policy-map interface gigabitEthernet 0/1.5:

Class-map: Servers (match-all)

0 packets, 0 bytes

5 minute offered rate 0 bps, drop rate 0 bps

Match: access-group 2407

Traffic Shaping

Target/Average Byte Sustain Excess Interval Increment

Rate Limit bits/int bits/int (ms) (bytes)

1048576/1048576 32768 131072 131072 125 16384

Adapt Queue Packets Bytes Packets Bytes Shaping

Active Depth Delayed Delayed Active

- 0 0 0 0 0 no

After amount of time this Traffic Shaping disappears and traffic goes uncontrolled....and i thing it's happened when initializing bgp peering...

Blue

Re: Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

Your service policy needs to be applied to the physical interface gig0/1. The traffic shaping will not work when applied to the subinterface.

Please rate helpful posts.

Dave

New Member

Re: Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

I'm not quite sure that service policy is applied to the physical interface because it's work in similar configuration on other NPE-G1, and as i see in restrictions of DTS it's says:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dtdts.htm#1019899

DTS does not support the following:

* Fast EtherChannel, Tunnel, VLANs, and dialer interface

* Any VIP below a VIP2-40

And i understand VLAN's - vlan interfaces not subinterfaces

P.S.If it helps in the chassis i had an module (PA-2FE-TX) fault i removed the module and router seams to work ok, but not shaping...

New Member

Re: Cisco 7206VXR npe-g1 DTS traffic shaping trouble....

The problem is solved there is a bug: CSCsh67773

312
Views
0
Helpful
5
Replies