cisco 7507 ios upgrade & master processor can't console in
1.)I wish upgrade IOS for Cisco 7507 from rsp-pv-mz.120-10.S1.bin" to 12.0(32)S3 . I've solarwinds tftp with me. Please advise the necessary steps.
2.) The router have 2 processor. 1 Master & 1 Slave. However i can't console in my laptop to the master processor but It was ok if i console in through slave processor. It will prompt slave# . Please advise.
Please advise . Your effort shall be highly rated.
Ensure that a console terminal is connected to the console port (on the RSP or RSP7000) and that your console is turned ON.Check the hardware slot if the Master processor.For upgrading the processor refer URL
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...