10-11-2007 02:17 PM - edited 03-03-2019 07:08 PM
Excuse me if this is a dumb question, I'm new to configuring Cisco routers. I had a Cisco 827 sitting on the shelf for the past year and decided to get it working. I reset it using the "erase" command and power cycled it. I have my console cable connected to it and see all the text up to the point it asks if I want to configure it. At this point it will not accept any input from my PC. I'm using Window Hyper-terminal and have tried all the different terminal types. I also noticed it will not detect a "break" command when booting.
Thanks, Ron
Solved! Go to Solution.
10-11-2007 05:08 PM
Likely trouble on PC serial port or console cable. Replace and try again.
10-11-2007 05:08 PM
Likely trouble on PC serial port or console cable. Replace and try again.
10-17-2007 02:10 PM
A new console cable seems to have done the trick. Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: