10-11-2007 02:17 PM - edited 03-03-2019 07:08 PM
Excuse me if this is a dumb question, I'm new to configuring Cisco routers. I had a Cisco 827 sitting on the shelf for the past year and decided to get it working. I reset it using the "erase" command and power cycled it. I have my console cable connected to it and see all the text up to the point it asks if I want to configure it. At this point it will not accept any input from my PC. I'm using Window Hyper-terminal and have tried all the different terminal types. I also noticed it will not detect a "break" command when booting.
Thanks, Ron
Solved! Go to Solution.
10-11-2007 05:08 PM
Likely trouble on PC serial port or console cable. Replace and try again.
10-11-2007 05:08 PM
Likely trouble on PC serial port or console cable. Replace and try again.
10-17-2007 02:10 PM
A new console cable seems to have done the trick. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide