Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 836 Bridge problem

hi,

I have the following situation at the moment,

Internet (1 Public ip) --> Cisco 836 --> Cisco Pix 501 unlimited

What i want is that the public ip is bridged to the Pix501 Outside interface.

The IOS version on the router is 12.3

I have the following configuration but i can get it working

interface Ethernet0

no ip address

no ip route-cache

bridge-group 1

!

interface ATM0

no ip address

no ip route-cache

no ip mroute-cache

no atm ilmi-keepalive

pvc 0 8/48

encapsulation aal5mux

!

bundle-enable

dsl operating-mode auto

bridge-group 1

hold-queue 224 in

!

bridge 1 protocol ieee

The 'bundle-enable' seems not supported any more in IOS 12.3

And in the pix501 the following settings

vpdn group pppoex request dialout pppoe

vpdn group pppoex localname $USER

vpdn group pppoex ppp authentication pap

vpdn username $USER password $PASSWORD

I can get it working. Someone have an idea?

2 REPLIES
Silver

Re: Cisco 836 Bridge problem

New Member

Re: Cisco 836 Bridge problem

Did you ever found a working solution for this?

149
Views
0
Helpful
2
Replies