About 24 hours ago one of our routers that's been running for years suddenly dropped connection. We started to troubleshoot and so far haven't been able to rule out OSI Layer 1.
I've spoken to our ISP (Nildram/Opal) and they're still running tests, but each of the techmonkeys on the phone keep saying that "initial line tests show the line is good, I'll get our engineering team to run more tests." I'm still waiting...
On the router I've run:
sh int atm0 and I get ATM0 is down and down
sh dsl int atm0 and I get line has not yet been activated
sh int dialer0 and I get Dialer0 is up and spoofing
The Tx and Rx lights are going ballistic and CarrierDet LED is off.
I know no-one has changed anything on there as only I have access. I know our firmware is probably quite old, but I don't see why that would cause it to suddenly stop working.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.