I have obtained a Cisco 837 ADSL router, but the image has been damaged so the IOS needs reloading. How do I go about putting the image back on for this Cisco so it restores it as new (factory defaults). Thanks
If your IOS is damaged the router will be going to rommon mode on power cycling the router you will see a prompt like this rommon 1>
Now, Connect your system and router using a straight through cable. Assign an ip address to your PC/laptop (for example) 184.108.40.206 with a netmask of 255.255.255.0 and the default gateway as 220.127.116.11. Before this download the tftp server (solarwinds is good). Place the IOS image on the root directory of the TFTP server and start the tftp server. Now assign the following commands and the commands are case sensitive.
TFTP_SERVER=18.104.22.168 <------- PC/Laptops IP address.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...