Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 837 - SDSL 512/512 or not ?

Just wondering if anyone knows if the Cisco 837 can be configured for a 512/512 SDSL connection? The SDSL connection is just a bridge connection (/30) where you get one static IP and the other static IP is the gateway on Telstra's end.

If the 837 can support a SDSL connection, does anyone have a config for it? Or would the config be the same as a ADSL bridge connection?

Thanks in advance.

3 REPLIES
New Member

Re: Cisco 837 - SDSL 512/512 or not ?

I think the 878 supports SDSL (G.SHDSL). The 877 router supports ADSL2/ADSL2+ and is very similar to the 837.

Purple

Re: Cisco 837 - SDSL 512/512 or not ?

Hi,

We've used the 837 for 'symmetric' ADSL rates of up to 512k/512k.... However, the problem I see is that you are hoping to use this router for an SHDSL link - that is not possible with the 837 and as the previous poster mentioned, you will need to look at a different platform.

I have used the 828 and also the 1721 + WIC-1SHDSL on the Telstra network but I'm sure the newer platforms would work just as well...

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Cisco 837 - SDSL 512/512 or not ?

Thanks for all your replies.

I'm using a standard bridge config on the 837 with pvc set to 8/35 but debug all is giving me weird results. Can anyone interpret the debug?

*Mar 1 00:02:33.043: ILMI(ATM0): Sending ilmiColdStart trap

*Mar 1 00:02:33.043: ILMI(ATM0): No ILMI VC found

*Mar 1 00:02:33.043: ILMI: Encapsulation error on o/g ILMI Pdu (ATM0)

*Mar 1 00:02:33.043: ILMI: Unable to Send Pdu out

*Mar 1 00:02:33.055: STP: opt: Bridge group 1: get ports: no free chunk available

*Mar 1 00:02:33.055: ATM0(O):

Here is a snip of the ATM interface.

interface ATM0

no ip address

no ip mroute-cache

no atm ilmi-keepalive

dsl operating-mode auto

bridge-group 1

hold-queue 224 in

pvc 8/35

encapsulation aal5snap

151
Views
2
Helpful
3
Replies
CreatePlease to create content