I have a 837 it was running k9o3y6 123-14.T2 this did connect ok thru the ATM interface, but started getting continual tracebacks, so up graded to 123-14.T5 but now cannot get a connection, the atm interface is down and down, The ADSL RXD and TXD are continually flashing when no ADSL is connected, when i connect the ADSl line the ADSL leds stop flashing for a short time (stay on) every minute or so then start flashing again, it does not connect. debuging ATM does not show anything
tried that made no-difference, the ADSL leds stay hard on for a few seconds then start flashing fast again, I am beginning to suspect H/W as i can connect a linksys ADSl router and it comes straight up,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...