I issued a "erase start" command on my cisco 837 router. After that i'm not able to telnet/hyper terminal to the router now. Will this erase start erase off the image file? What can i do to access back the router? Thks!
make sure your Hyperterminal settings are 9600 (speed), 8 (databits), none (parity), 1 (stopbits), these are actually the defaults, you might want to try different speed settings, see if that makes a difference. You could also try the ´latest´ version of Hyperterminal, which you can download below.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.